Sunday, October 23, 2011

Hobie "Horizontal Rod Holder"

 
One of the inherent problems we have as Kayakers is the small amount of space to put our tackle. We don't have the luxury of a huge deck to store our equipment like those that are fishing out of a bass boat. Well Hobie has helped resolve at least one of our problems this year with increased rod storage space. Hobie has come out with the "horizontal Rod holder". The holder consist of two pieces, a rod protector tip and a rod butt holder/shelf which attach to the hull. 

Mounted on the front of the kayak is the rod tip protector. The rod tip protector is formed from hard plastic and attached to the kayak by three stainless steel bolts, washers, and nuts.The other part of the rod holder attaches to the middle of the kayak and holds the reel close against the hull. It is attached in a similar fashion with three provided stainless steel bolts, washers, and nuts. If reaching inside the hull to mount the holder is a problem then screws are also supplied.
After mounting the rear rod holder/shelf there is an eyelet post to be installed. It is an attachment point for the rubber strap that secures the rod when not in use. I would suggest putting a rod in the holder and stretching the rubber strap in place to find the point to mount the the eyelet.
I found the mounting of the rod holder to be very easy.  Hobie provides clear instructions with illustrations to show the processes of mounting the unit on the kayak. 
I mounted one rod holder on each side of my kayak late one afternoon and still had plenty of daylight to go fishing!
 
TIP : When placing the rod in the holder turn the eyelets of the rod toward the kayak. Most of the time when bumping in to trees the kayak hull will hit the tree first but if the tree trunk is just at the right level it will bend the rods eyelets back.
I've been using the "Horizontal Rod Holders" for four months now. I am extremely pleased to have them on the kayak. I spend about 90% of my time bouncing off trees while I'm fishing heavy timber. I use to have my rods mounted vertically. I spent most of my time leaning over pulling my rods out of the trees I had just passed. I tried laying them on the surface of the kayak in front of me but that to was a mess having three rods scattered in my lap. With the horizontal holders I am able to bring three rods with me in my kayak and be very comfortable. Four can be done but it sometimes gets a little crowded when bass fishing as I primarily do. 
As mentioned above I did mount a horizontal holder on each side of  my kayak. This presented an issue with the existing anchor trolly. So on the side where I have my anchor trolley I only mounted the front rod protector. The rear holder/shelf looked like it might be something the trolley could hang on so I chose to leave it off for now. On the Hobie Outback there is a strap provided to secure the paddle. It is is the perfect place to hold the rear of the rod to the side of the kayak. The anchor trolly can be used with the a rod in the holder but it does restrict the full motion of the trolly.
One of the beauty's of the rear holder is the design of built in shelf. There is a rubber strap that will securely hold your rod in the holder if you are in rough water.  While you are are fishing, you are able to remove the strap and let the rod sit securely in the shelf. At first I was afraid the rod would fly out of the shelf and in to the water. This has happened once as I was passing a low lying limb and it grabbed the rod on the way by.
In the last few months I have found myself using the rubber strap mostly when I'm securing two rods at the same time. You can place one rod in the holder and have it sitting on the shelf for easy access.
The Horizontal rod holder is one of those inventions that you say "Duh, I wish I would have thought of that".
The rod tip protector is very sleek and slides off trees and other obstructions while protecting you rods tucked away inside. The rear of the holder provides a way to securely attach your rods with a strong rubber strap. If your out fishing you can release the strap and still have a shelf for the rod to sit on for quick access.
I've banged it around for the last few months and it is still doing a great job. I feel that it is one of the best added features I have put on my kayak

Shaun Russell
russell.Shaun@ymail.com
horizontal rod holder kit (part# 72021060)
http://static.hobiecat.com/digital_assets/hobie-kayak-parts-accessories-fall-2011.pdf
http://www.hobiecat.com/forums/viewtopic.php?f=26&t=35650

1 comment: